I have a set of HAD from Jesse that I need to get rid of. Purchased from Jesse in July 05'.

The front is 29.5" static and has a long travel slip. The axle end is 1410 and the t-case end is setup with toyota minitruck flange and joint (41* of movement). I also have the flange to bolt it to a D300 front output. Can be shortened or lengthened by local d-line shop or send it to Jesse for a quality job.

http://pics.montypics.com/judd/2005-08-15/1124130904_dshaft.png


The rear is 51" static and has a slip unit as well. The axle end is 1410 and the t-case end is 1350.

Both shafts are basically new. They have one dune trip on them, no abuse... I paid over $800 for them.

I will seperate or sell together.

Both = $450.00

Or, $250 for the front and $200 for the rear...

Thanks, Judd

Judd, am measuring my stuff this evening and will let you know as soona s I have a chance. Mainly interested in the front.

Gui

BTW, plan is to install ona front 231 transfer case, do you know if the D300 output the same as the 231? What kind of u-joint?

Gui

You have a PM

quayle, pm'd ya back, let me know

gui, the mount to the d300 is using a toy minitruck joint, you would need a new yoke, I might have one, I'll check...

Judd,

Thanks, let me know if you have another yoke. I am very interested in the front.

Gui

Gui, not sure if the flange will work on a 231... Both d-shafts are still available.

TTT

Judd,

Woudl you be able to take a picture of the front shaft yoke, you have, and maybe some measurements? What size u joint will fit on the yoke?

Thanks,

Gui

Gui, I'll get some pics up this weekend and get ya some measurements... thanks, Judd

Thanks Judd

Gui

Here is a pic of the two driveshafts.

The front will come with the flange that will allow you to bolt it up to a stock front output on a D300, the front flange and joint will net you 41* of angularity!

http://pics.montypics.com/judd/2005-08-22/1124745946_driveshafts.png


Let me know if anyone has any questions! thanks, Judd