Who Makes Spacers From The Unimog 404 6 Bolt Pattern To A Standard 8 On 6.5 Bolt Pattern Without Doing The Disk Conversion? I Want To Run The Hummer Beadlocks.

I talked to a guy here on the board that made his own. I believe he works in a machine shop. He was supposed to make me a set but I haven't talked to him in a while. I'll try to get in touch with him.

Uhh, why not just recenter the Hummer locks like every other normal person would. Probably even cost less

Uhh, why not just recenter the Hummer locks like every other normal person would. Probably even cost less


Might be the desire to maintain a decent scrub radius? Portal axles typically need a lot more backspacing than a conventional axle to keep the steering centerline close to the wheel centerline....


:usa:

Mad Mac is machining my mercedes 6 on 205mm to 8 on 6.5" adapters.