McDerry
09-03-2005, 08:28 PM
well, Im sorry if this has been discussed, sr-4 is to short of a word for the search client.
well, pulled a 85 mustang engine and drive train then stuck the engine into friends f-150. now we have this 4 speed toploader kicking about.
The zuki, 2.8L ford powered, is in need of a shorter transmission. Well the sr-4 has kinda volenteered. Only big catch is so far the mustang disk was 10 inches in width, the ranger disk is 8 7/8 in width, thats just over a half inch in size. Now before i go trying to squeeze the ten inch disk under a pressure palte built for a 9 inch disk, is there anotehr smaller disk out there from a different source to fit this. Its the 1 1/16 input shaft too, forgot the spline count at the moment.
Thoughts suggestions, what not.
well, pulled a 85 mustang engine and drive train then stuck the engine into friends f-150. now we have this 4 speed toploader kicking about.
The zuki, 2.8L ford powered, is in need of a shorter transmission. Well the sr-4 has kinda volenteered. Only big catch is so far the mustang disk was 10 inches in width, the ranger disk is 8 7/8 in width, thats just over a half inch in size. Now before i go trying to squeeze the ten inch disk under a pressure palte built for a 9 inch disk, is there anotehr smaller disk out there from a different source to fit this. Its the 1 1/16 input shaft too, forgot the spline count at the moment.
Thoughts suggestions, what not.