Just thought I share. might help someone.

This is a 26" aluminum radiator (19" high I think). Went to a sheet metal shop and had them weld the aluminum angle taps to the radiator. then built the brackets at home.

- Rico.

another

If you had used a Mark VIII fan, its shroud would have covered the whole radiator, top-to-bottom.

heres a taurus fan. drilled thur the stock housing and welded the nuts on :D

http://www.pirate4x4.com/forum/attachment.php?attachmentid=202405



and the cooler. same theng here all the nuts are welded on.

http://www.pirate4x4.com/forum/attachment.php?attachmentid=202404