need to know the best way do it.
do i just cut the ends off and weld on new housing ends on ?
or grind the inner tube weld off and pull the tube then cut , put back in and weld it or what? :smokin: :confused:

well let me have it :nuke: :flipoff2: :flipoff2:


ok figured out how to narrow it .

is an EB axle centered ?and wich side is longer ?

bueller, bueller :rolleyes:

Cut the inside, put the tube back in and reweld it.

ttt please

I know the guys up here use some sort of jig to line things up. I haven't seen it though. They use it for putting 9" ends on dana 60's.

cut the ends off and weld them back on, you need a jig though to make sure evreything lines up

I made alignment disks w/ a 1.5" id to fit in place of the 2 carrier bearings and the axle bearing, then slide some 1.5" tube inside.

Thanks for all the info guys i now have a narrowed to Eb width front and rear axle.
actually the rear is 60 wms-wms and front is like 59.5 wms-wms is that bad :eek:

Originally posted by alx
Thanks for all the info guys i now have a narrowed to Eb width front and rear axle.
actually the rear is 60 wms-wms and front is like 59.5 wms-wms is that bad :eek:

:eek::eek: :eek: Hell Ya, that's bad...









































Just kidding..should be fine:D

thanks i needed a good scare :flipoff2: