PDA

View Full Version : 999 trans help ?????

CaseyP
10-09-2005, 06:34 PM
insaled a new torque conv in my 999 in my tj, made sure everything was lined up, and when i fired it up today, i had a metal on meta sound coming from it:mad: any ideas on where this is coming from?

Casey
xgeekstarx
10-09-2005, 07:40 PM
5 bucks says you didn't seat the converter all the way in.
CaseyP
10-09-2005, 09:22 PM
its set in all the way...i made sure of that
JohnC
10-09-2005, 10:52 PM
Hmmm, I replaced my 999 about a year and a half ago, but I don't remember any gotchas. Could the lower dust cover be rubbing?
CaseyP
10-09-2005, 11:10 PM
on the 999 u use a a scale to check depth, it supposed to be at 1/2" from the edge of a straight edge..and it was exactly a 1/2". a 999 isnt like a chevy tras where it clicks. all im supposed to do it rotate while pushing on the TC, which i did, and it seated.

i pulled 1/2 of the dust cover off(2 piece design) and it still made the noise. im gonna pull the other half tomorrow and see what happens.

the FSM says that it could be a broken drive plate as well as a couple other things in the diagnostics section of the book. For those with the FSM handy...its section 21-236.

im at wits end with this and am ready to load it up on a trailer and take it to a shop
craigellis77
10-10-2005, 07:47 PM
did you put any fluid in the TC before installing? i've always done that without any problems

oh and was the TC new or reman?
CaseyP
10-10-2005, 07:56 PM
yes i put fluid in the TC before installing. it was a new one from the dealer
ksmith
10-11-2005, 05:34 PM
I had the top bolts on an aw4 come out and the upper cover came down into the flywheel. Not sure if this could happen with yours. Just my .02

k
actionpaintball
10-12-2005, 06:48 AM
Throw out bearing installed backwards?
nukblazi
10-12-2005, 11:14 AM
Pull it apart and look for impact marks?
ky1tonyj
10-12-2005, 01:11 PM
Throw-out bearing? Must be some new-fangled automatic.
CaseyP
10-12-2005, 07:40 PM
Throw out bearing installed backwards?


you are band from this thread:flipoff2:
chad3
10-13-2005, 07:49 AM
Is the engagement fork installed correctly? Nah, anyway,
I had a few issues with some of the bolts on mine, first I forgot to tighten all them down so it was hitting. Not bad cause I did wrench them down, but enought to make a noise, more of a click, but you get what I mean. Just a thought.