Gauge Help

[East Coast Ghost]

I amin the process of rebuilding the dash on my yj, i am making it a flat stile like a cj. For the people who have also replaced the factory gauges with aftermarket what ohm range gas gauge did you all end up using thanks for your help.

ECG

[FrankyYJ]

I used this: Autometer 2641 - 2 1/16 Fuel Lever (0 empty/90 full)

[East Coast Ghost]

hay thanks for the help.

[Schmozilla]

No aftermarket gauge will work with the YJ i dont think.... I think its some goofy ohm interval... I could be wrong though i cant remember if it was the YJ or the CJ stuff that is goofy

[Jaffer]

To the best of my knowledge ...

CJ Sender Specs ...
10 ohms full
73 ohms empty

YJ Sender Specs ...
120 ohms - full
10 ohms - empty.

TJ Sender Specs ...
20 ohms - full
220 ohms - empty.
(Fuel level signal wire goes through the PCM)

[JEEPSKEET]

Heres a good write up on it...
http://www.off-road.com/jeep/reviews/dash/rlwdash.html

[Mo]

:cow:

[kury]

I'm not sure how accurate these #'s are from Jaffer..

To the best of my knowledge ...

CJ Sender Specs ...
10 ohms full
73 ohms empty

YJ Sender Specs ...
120 ohms - full
10 ohms - empty.

TJ Sender Specs ...
20 ohms - full
220 ohms - empty.
(Fuel level signal wire goes through the PCM)

I know these are right..

0 E-90F
73E-10F
240E-33F
240-33.5 (not sure which is Empty & which is full?)
16E-158F

these numbers are from http://sw-performance.com/products/products.aspx?productcategoryid=63&ispod=0


And if your looking for design ideas.. here's mine its in a CJ-7 though... and I used the gauges from the link above..