Anyone install a ram using the Stock Ford Coil Sprung suspension? Looking up under mine, and trying to find a place for the ram to sit.. the track bar eliminates the place most people would normally mount theirs.

Here's something off the wall... I maybe an idiot.. but could I mount the ram on the track bar, connecting to the drag link?

Other then that.. it's all pretty tight up there.

BTT,
Anyone have any suggestions?

put it were your steering stableazer is

That could work, but it would connect to the drag-link instead of the tie-rod.. Was still waiting to hear the general consensus of connecting it to the drag-link vs. the tie-rod.

Well, after looking at it further.. I've decided that the track-bar will have to be relocated..
Thinking of fabbing a mount on the top of the axle that will relocate the trackbar mount to the top of the axle housing. Will 5/16th or 3/8th plate be thick enough for this? I don't forsee a lot of fore/aft movement (bending) stress on it, just left and right.. so a large surface area onto the axle housing will be good right?

That's what you will have to do, Just make a bracket to move it up 4 to 6 " and remount it.