|
: Dana 44 pinion yoke to toyota shaft TatorZuk 10-10-2005, 07:43 PM What are you guys with Dana axles using for a pinion yoke/flange to mate to your Toy shafts??? I know Jess makes this billit flange... http://www.highangledriveline.com/dana_44_billit.JPG I'll bet not everyone's using one of these though. zukfreak56 10-10-2005, 08:52 PM make new shafts. ryan_ackerman 10-10-2005, 09:25 PM how much does one of those run? 95geo 10-11-2005, 06:23 AM i used the conversion joint from rockford driveline but im going to be looking for another way to make it work because im not giving them my business anymore. probably a flange whether i buy it or make it..... TatorZuk 10-11-2005, 09:56 AM I used the conversion joint from rockford driveline. You wouldn't still have the part# for that joint still around would you?? billj 10-11-2005, 10:15 AM one d-shaft from a Dana axled vehucle one d-shaft from a Toyota vehicle cut, weld Done............. 95geo 10-11-2005, 10:52 AM their web site doesnt seem to be working for me.....call them up and tell them you want a conversion ujoint that goes from a 1310 spicer to a toyota mini truck driveshaft, they are about $20. order a few spares while your at it, the seals dont work very well and you have to constantly grease them or they will dry up. XTREME4X4PARTS 10-16-2005, 12:12 PM i just fabbed up some toy/jeep shafts for my dana 300 conversion, only took a couple of hours and they were bolted in. some jeep shafts slide right inside some yota shafts. easier if you find the right sizes. 95geo 10-16-2005, 06:03 PM rockford driveline part number: k721 TatorZuk 10-16-2005, 06:29 PM rockford driveline part number: k721 Thanks.:D whitfield 01-27-2006, 07:41 AM THe Isuzu Rodeo comes with a flanged metric D-44 Rear pinion flange, Not an exact match but very adaptable. TatorZuk 01-27-2006, 03:15 PM one d-shaft from a Dana axled vehucle one d-shaft from a Toyota vehicle cut, weld Done............. Thats exactly what I did for the front.... http://i5.photobucket.com/albums/y174/TatorZuk/IM001571.jpg http://i5.photobucket.com/albums/y174/TatorZuk/IM001573.jpg For the rear...I bought the billit from Jess at HAD... http://i5.photobucket.com/albums/y174/TatorZuk/IM001576Small.jpg TatorZuk 01-27-2006, 04:19 PM Forgot to mention...both ends of the t-case have Rockrats adapters on them...gotta' get his plug in too.:D Shadow Crawlers 01-27-2006, 06:22 PM I just ordered front and rear brand new large flanges :D. Will get them machined out next week so they are vibe free verses a die grinder, for now I'll rig up some smalls. | |