yager
03-17-2002, 05:34 PM
Hey all,
Here's some of what I did this weekend.
http://www.yager.net/zukin/zukipuke/half-cab-1.jpg
I used the tail gate to cover part of the cab opening. Its like it was almost designed to fit in there. Plus its light weight and sturdy. I still need to pretty it up a bit.
Basically its just sitting on the floor pan like so....
http://www.yager.net/zukin/zukipuke/half-cab-2.jpg
and welded where it hits the targa bar on each side. Its a nice fit near the targa too...maybe 1/8" gap on each side.
Now to figure out how long to make the wheelbase.....is +10" too much ?
-mike
Here's some of what I did this weekend.
http://www.yager.net/zukin/zukipuke/half-cab-1.jpg
I used the tail gate to cover part of the cab opening. Its like it was almost designed to fit in there. Plus its light weight and sturdy. I still need to pretty it up a bit.
Basically its just sitting on the floor pan like so....
http://www.yager.net/zukin/zukipuke/half-cab-2.jpg
and welded where it hits the targa bar on each side. Its a nice fit near the targa too...maybe 1/8" gap on each side.
Now to figure out how long to make the wheelbase.....is +10" too much ?
-mike