masterbeavis
10-23-2005, 03:36 PM
I have been stumbing over this crap for a long time, its time to get rid of it.
No shipping, dont ask.
460 stuff. Blocks, cranks, flexplates, starters, alternators pulleys, clutch fans, heads yada yada yada
10" craftsman table saw. Needs a belt, motor works, no fence or accessories.(pickup only)
Toshiba dual DVD player, Model SD-3109 condition unknown
Big block GM radiator, with A/T. Last used in a '72 blazer. might leak, I dont remember. Has significant lines inside for trans cooler
Astro van raditor. Did not leak
Astro van ABS computer
Various AC condensors. make great tranny coolers.
Box of emissions crap. Fits fords from 80's to 70's
Ford/york alum AC Pump. Long stroke. Dont know if it worked suction did not feel all that great whlie being spun by hand. Clutch is someplace, no idea where.
73 and up GM sway bar with D44/10B brakets
351M flywheel with plenty of meat
Push along line painter by rustolem uses inverted spray cans
Big assed tent, needs poles. Fiberglass poles are damaged, In great shape otherwise.
A burned 130A big rig alternator. Would make a good core for gettin one for an on board welder.
XJ D35C rear axle, complete minus ebrake cables
6 4' florescent lights. GONE
Ford/York cast iron AC pump. Worked good., GONE
Various ford 1G alternators. Prolly dont work. Stamped 40 and 60A spoken for
Ford 2G flamethrowers GONE
T18 BBF alum belhousing, spoken for
Commercial grade mop bucket and wringer , spoken for
a couple of large case 1g alternators (75a) alternator ,deal pending
GM 10si 60a (3) I think. One worked(bad diode) one supposedly worked good, other NFG spoken for
A few cute lookin pots for flowers GONE
No shipping, dont ask.
460 stuff. Blocks, cranks, flexplates, starters, alternators pulleys, clutch fans, heads yada yada yada
10" craftsman table saw. Needs a belt, motor works, no fence or accessories.(pickup only)
Toshiba dual DVD player, Model SD-3109 condition unknown
Big block GM radiator, with A/T. Last used in a '72 blazer. might leak, I dont remember. Has significant lines inside for trans cooler
Astro van raditor. Did not leak
Astro van ABS computer
Various AC condensors. make great tranny coolers.
Box of emissions crap. Fits fords from 80's to 70's
Ford/york alum AC Pump. Long stroke. Dont know if it worked suction did not feel all that great whlie being spun by hand. Clutch is someplace, no idea where.
73 and up GM sway bar with D44/10B brakets
351M flywheel with plenty of meat
Push along line painter by rustolem uses inverted spray cans
Big assed tent, needs poles. Fiberglass poles are damaged, In great shape otherwise.
A burned 130A big rig alternator. Would make a good core for gettin one for an on board welder.
XJ D35C rear axle, complete minus ebrake cables
6 4' florescent lights. GONE
Ford/York cast iron AC pump. Worked good., GONE
Various ford 1G alternators. Prolly dont work. Stamped 40 and 60A spoken for
Ford 2G flamethrowers GONE
T18 BBF alum belhousing, spoken for
Commercial grade mop bucket and wringer , spoken for
a couple of large case 1g alternators (75a) alternator ,deal pending
GM 10si 60a (3) I think. One worked(bad diode) one supposedly worked good, other NFG spoken for
A few cute lookin pots for flowers GONE