Jeepkid8037
10-23-2005, 04:29 PM
1981 CJ7-$4,000
Chevy Vortec V6-Painless wiring harness, pushbutton start, runs great
SM420 tranny...7:1 1st gear, all new bearing and seals
D300 with a 4:1 kit, all new bearing and seals
d30 front, locked
amc 20 rear
35" Swampers
Herculined interior
GM tilt column
Full hard doors
Soft top
Bucket seats
5 point harnesses are included
I will inlcude spare computers/chips. TJ fender flares, and all the old guages/switches. The old dash is too beatup top re-use.
The floors are solid and there is a little rust on the front drivers fender, nothing major. The brake lights, turn signals, and headlights are all wired they just need to be spliced into the GM tilt column. Right now it has running lights. It gets DW around 35MPH, but if you are going faster than that is drives good. I'm just getting done stripping off the old herculiner paint job and getting ready to throw a new coat of paint on it. The body has some dents.
Located in the SF Bay Area
PM or email me with any questions.
RXPIZ409@aol.com
Chevy Vortec V6-Painless wiring harness, pushbutton start, runs great
SM420 tranny...7:1 1st gear, all new bearing and seals
D300 with a 4:1 kit, all new bearing and seals
d30 front, locked
amc 20 rear
35" Swampers
Herculined interior
GM tilt column
Full hard doors
Soft top
Bucket seats
5 point harnesses are included
I will inlcude spare computers/chips. TJ fender flares, and all the old guages/switches. The old dash is too beatup top re-use.
The floors are solid and there is a little rust on the front drivers fender, nothing major. The brake lights, turn signals, and headlights are all wired they just need to be spliced into the GM tilt column. Right now it has running lights. It gets DW around 35MPH, but if you are going faster than that is drives good. I'm just getting done stripping off the old herculiner paint job and getting ready to throw a new coat of paint on it. The body has some dents.
Located in the SF Bay Area
PM or email me with any questions.
RXPIZ409@aol.com