46willys
10-24-2005, 10:43 PM
Getting ready to move and I need to get some of this stuff out of my garage.
I have an SM465 with new clutch fork. It comes with a big bore bell housing for the sm465 it is connected to a rockwell T221...it is the married version that they only offered for a few years, very beefy. Have pics upon request, came out of running trail rig. Must pick up. Somewhere around Terre Haute Indiana. Lets start out at 320$
Also have a dana 300 that is in perfect condition. Came from a running CJ, its not the short tail shaft version...bone stock. 195$ plus shipping.
Also I have a Ford Nine inch third member all set up by a shop using all solid shims, no crush sleeves. The 3rd is a stock (not nodular) 3rd member, the gears are new 4.56's It also comes with a 28 spline mini spool. New bearings. Low miles. To cover the bearings gears and setup I need 300$
Dana 44 60 inches WMS TO WMS Pass drop, Brand new 4.56 gears scout outers(5 on 5.5) Set up by extreme performance in Bloomington Indiana. Will need new rotors. narrowed to use scout long side shaft and Jeep cheroke chief short side. To cover gears and set up cost I need 400$, make and offer on this one if you can pick up.
Also have a some dana 44 flattop knuckles bone stock never been touched.
100$ plus shipping....I have some chevy small spindles to use with ford 5 on 5.5 hubs. 50$ plus shipping.
I am sure I will run into some other things has I cont to clean out the garage.
I have an SM465 with new clutch fork. It comes with a big bore bell housing for the sm465 it is connected to a rockwell T221...it is the married version that they only offered for a few years, very beefy. Have pics upon request, came out of running trail rig. Must pick up. Somewhere around Terre Haute Indiana. Lets start out at 320$
Also have a dana 300 that is in perfect condition. Came from a running CJ, its not the short tail shaft version...bone stock. 195$ plus shipping.
Also I have a Ford Nine inch third member all set up by a shop using all solid shims, no crush sleeves. The 3rd is a stock (not nodular) 3rd member, the gears are new 4.56's It also comes with a 28 spline mini spool. New bearings. Low miles. To cover the bearings gears and setup I need 300$
Dana 44 60 inches WMS TO WMS Pass drop, Brand new 4.56 gears scout outers(5 on 5.5) Set up by extreme performance in Bloomington Indiana. Will need new rotors. narrowed to use scout long side shaft and Jeep cheroke chief short side. To cover gears and set up cost I need 400$, make and offer on this one if you can pick up.
Also have a some dana 44 flattop knuckles bone stock never been touched.
100$ plus shipping....I have some chevy small spindles to use with ford 5 on 5.5 hubs. 50$ plus shipping.
I am sure I will run into some other things has I cont to clean out the garage.