T-18 identification [Archive]


Pirate4x4.Com > Brand Specific Tech > International Harvester > T-18 identification PDA : T-18 identification mudtruck44 03-18-2002, 09:05 AM I just got a T-18 mated to a twin stick Dana 20. I thought maybe it was Jeep, but I also thought it could be Scout. Did that combo ever come in an International? ol John Henry 03-18-2002, 09:22 AM Yes What’s the input shaft length, spline count and diameter?? :question: jdjanda 03-18-2002, 09:23 AM Yes IH offered T18's. Would have to see some pics to identify, but a twin stick D20, would have been from an Scout 800, if it is from an IH. Joe mudtruck44 03-18-2002, 09:39 AM I think the input shaft is probably a little less than an inch in dia. If this is a T-18 from an early Scout is there any problems with it? Is the input shaft weak? What are the gear ratios? RustoleumWhite 03-18-2002, 09:47 AM yes, in two variaties. If it has a LONG input shaft, then it is off an V-8 equiped Scout. Most likely a later 800 serise, cause I can think of any Scout II's that came factory with a twin-stick (did they??) If it has a smaller input shaft, then it may be from a 4-cylinder 800 serise. Do you have the bell-housing?? if you do, and it is an IH 4-cylinder piece, let me know. I may be intrested. Unfortunatly I don't have the dimentions handy, or you could measure and check... but I'm sure someone does.... ol John Henry 03-18-2002, 01:53 PM Originally posted by mudtruck44 Is the input shaft weak? Ever seen a FORD input shaft:question: jdjanda 03-18-2002, 03:17 PM Originally posted by RustoleumWhite if you do, and it is an IH 4-cylinder piece, let me know. I may be intrested. Unfortunatly I don't have the dimentions handy, or you could measure and check... but I'm sure someone does.... I thought the 800's with V8 still used the short input? The long input is around 18 inches in total length, with about 14.75 stickout. The short input has about 8 inches of stickout. The numbers are off the top of my head and may be totaly wrong, so take it with a grain of salt. Joe RustoleumWhite 03-18-2002, 04:20 PM Originally posted by jdjanda I thought the 800's with V8 still used the short input? The long input is around 18 inches in total length, with about 14.75 stickout. The short input has about 8 inches of stickout. The numbers are off the top of my head and may be totaly wrong, so take it with a grain of salt. Joe no the V-8's used a normal bellhousing and such... Not the small, "pancake" tilted bell.