Planned on using this for a future project. Just don't have the time at the moment. It's sitting in my living room taking up space. :mad3: <1k miles on rebuild.

Engine, I don't know much about the bottom end as I haven't gotten into it, I was told it is a 4 bolt main block, although I can't confirm this as I don't have the engine on a stand at this point. Top end, Harland sharp roller rockers. As seen in the picture. The heads are aluminum Corvette heads HEADS: 10088113...88-up...350..........Aluminum, 58cc, angle plug, raised "D" port exhaust, 1.94"/1.5" valves. These where used in Corvette's from 87-91. Also the ZZ seriese crate engines. :D. Aftermarket Milodon oil pan. The intake is a standard Edelbrock Performer Intake. (non EGR).

http://img.photobucket.com/albums/v297/rjorgens/Chevy%20350/Chevy_Rocker_1.jpg

http://img.photobucket.com/albums/v297/rjorgens/Chevy%20350/Block_Casting.jpg

Location posted to your left. $1000.00


-RJ

bump