Looking for ~16.5" D44 inner shaft [Archive]


Pirate4x4.Com > General Tech > General 4x4 Discussion > Looking for ~16.5" D44 inner shaft PDA : Looking for ~16.5" D44 inner shaft RustoleumWhite 03-20-2002, 03:26 PM Anyone know an aplication of a D44 inner shaft that is Approx 16.5" long. The WARN axle shaft length chart is of no use, needs to be 30-spline, 297X u-joint, and avaliable in an aftermarket alloy (does warn have "stock" aplications not shown on the site??) Is there any better sites with more shaft measurments? What is a Dodge short side?? thanks jdjanda 03-20-2002, 03:37 PM Originally posted by RustoleumWhite Anyone know an aplication of a D44 inner shaft that is Approx 16.5" long. The WARN axle shaft length chart is of no use, needs to be 30-spline, 297X u-joint, and avaliable in an aftermarket alloy (does warn have "stock" aplications not shown on the site??) Is there any better sites with more shaft measurments? What is a Dodge short side?? thanks Gee this would not be for an IH truck or T-all axle would it, huh, would it :D You'll have to try Dutchman or Moser. You can buy the Warn blanks and have them machined. Joe RustoleumWhite 03-20-2002, 07:03 PM What?!?! Knowone else has any sujestions?? Originally posted by jdjanda Gee this would not be for an IH truck or T-all axle would it, huh, would it :D You'll have to try Dutchman or Moser. You can buy the Warn blanks and have them machined. Joe :D no, custom RC front axle for my junk... :D hmm, how long is a t-all short side?? I wanted a stock length for cheap replacments (no cutting and re-splining) and an off-the-shelf alloy... cheaper than a blank and having it made (and warrenty).... Or are they?? What do the blanks and re-spline cost compared to a off the shelf WARN?? jdjanda 03-20-2002, 10:46 PM Originally posted by RustoleumWhite What?!?! Knowone else has any sujestions?? :D no, custom RC front axle for my junk... :D hmm, how long is a t-all short side?? I wanted a stock length for cheap replacments (no cutting and re-splining) and an off-the-shelf alloy... cheaper than a blank and having it made (and warrenty).... Or are they?? What do the blanks and re-spline cost compared to a off the shelf WARN?? Search grasshopper. I read a post not too long ago that stated Dutch or Moser used Warn Blanks for the alloy axles. I'm too tired to search for you tonight. But here is a start off the top of my head http://www.moserengineering.com http://www.dutchmanaxles.com 44Runner 03-21-2002, 12:48 AM My narrow track waggy short side shaft is ~16" in length from splined end to center of ujoint cap hole. just went out in the living room to measure it :D