ok i have a 1995 s-10 blazer its 4wd and 4 door wuts the stock rear end thats in it? thanks, and also will i be able to use my stock rear driveshaft after i lift it? around 5-7". thanks.

-Thomas

ok i have a 1995 s-10 blazer its 4wd and 4 door wuts the stock rear end thats in it? thanks, and also will i be able to use my stock rear driveshaft after i lift it? around 5-7". thanks.

-Thomas

Should be a 10 bolt and I Highly doubt you will be able to re use the driveshaft without getting it lenthened..:smokin:

Yup, the tiny 10, 7.5" ring gear, 28 spline, c-clip. I had my 94 4dr lifted without rear driveshaft mods, 5" or so, the slip has a lot of slip in it. If you need a longer one, look at a std cab shortbed 4wd S-10 rear shaft. It's just a few inches longer than yours. 4dr wheelbase is 107, pickup is 108.3.

ok thanks, is there anywhere other then a pick and pull place that i can just order that driveshaft?

-Thomas