Will a 205 from behind a c6 bolt onto a np435??

I ask because I'm going to check out a 435 and 205 tomorrow and he said the 205 came behind an auto and he just had to shorten the shifter rod to make them work together.

I want to know what to look for, like whether or not he had this rigged together (they're apart now). Thankya:D :D

You'll need the adapter for the 435, shouldn't be hard to find one... lots of Ford Trucks came with a 435. What transfer case you have now? Chances are it'll bolt right in place. All the Ford transfer cases used the same circular bolt pattern, but the 205 needs to have a Notch for the shifter linkage.

There are 2 output shaft sizes on NP435's. 28 and 31 spline. The 205's require a 31 spline output shaft. If you were to use a dana 20 t/c you would need the 28 spline output shaft. There are also 2 tailhousing/ adapter bolt patterns. A "square" pattern, and an "A" pattern(top bolts closer together than bottom". To top it all off, there are 2 different input shaft lengths. I believe 6.5" is the most common and prefered.

I don't know much about the NP205's. I would think they would all be interchangeable witht he correct adapter though.

Thanks, he said he had them together and working. I'll see for sure tomorrow. I'll let you guys know.

435's also came divorced from the 205's up until 77 ;)

Picked them up today. The 435 came with the adapter and the 205 was from behind a c6. They bolt together perfect. Thanks