|
roy jones 11-30-2005, 12:05 AM does anyone know if the straight axel out of a 78 bronco a hi pi 44 will fit into a 85 model bronco it has one of those fttb or some kind of axel in it that swiveles in the middle it looks like it will fit but i was wandering if anyone has done this before. any info would be great. because this is a daily driver thanks Kenny714 11-30-2005, 04:23 AM Sent you a PM. roy jones 12-01-2005, 01:14 AM thanks D-diesel 12-02-2005, 05:24 AM theres a crap load of info about sas of d44 over at FSB www.fullsizebronco.com good luck. animator 12-02-2005, 05:32 AM search. When I did my swap, pretty much everything I needed to know I read on this board. Kenny714 12-02-2005, 06:05 AM theres a crap load of info about sas of d44 over at FSB www.fullsizebronco.com good luck. That's where I sent him in my PM. :cool2: roy jones 12-02-2005, 08:59 PM search. When I did my swap, pretty much everything I needed to know I read on this board. looks like is going to be alot harder than i thought. i was just sure that it was a easy swap . everything lining up and bolting right in but no . i think i will junk it and find a older bronco animator 12-02-2005, 10:34 PM looks like is going to be alot harder than i thought. i was just sure that it was a easy swap . everything lining up and bolting right in but no . i think i will junk it and find a older bronco Actually it IS an easy swap, if you're compitent. Most difficult part for me was fabbing up a mount for the trac bar. Lars915 12-03-2005, 07:56 AM looks like is going to be alot harder than i thought. i was just sure that it was a easy swap . everything lining up and bolting right in but no . i think i will junk it and find a older bronco If you've got a good donor truck, it's a super easy swap, the hard part is making sure everything is aligned before you start drilling holes. roy jones 12-04-2005, 10:21 PM If you've got a good donor truck, it's a super easy swap, the hard part is making sure everything is aligned before you start drilling holes. hello fr om what i read the axle will hit the crossmember if it dont have a lift on it i just wanted to use the stock setup. the stock stuff is really strong and easy to get into. | |