|
bigtoyfreak 01-07-2006, 05:24 PM How do you check the bearing preload on the upper portal bearings? There are shims behind the bearing race in the portal box aswell and behind the bearing/seal retainer in the axle shaft. What clearance or tension should I have there? Cory Puffdragon 01-07-2006, 05:30 PM Im not 100% sure you need measurable preload, but the shims are behind the smaller bearing race. Ill chsck the book when I get board and let you know WOLF359 01-11-2006, 03:14 PM I'm looking for this too.... if anyone has it. Thanks. Puffdragon 01-11-2006, 05:37 PM Bearing play should amount to 0.08+_0.02mm Always try for the smaller play This is from the manual. bigtoyfreak 01-11-2006, 08:13 PM thx Puff :beer: Puffdragon 01-12-2006, 08:24 AM Told you I would get to it. I just wasent boared enough yet. If you ever have an emergency, let me know and i will do it faster next time. WOLF359 01-12-2006, 03:24 PM thank you P. Diddydragon. :) | |