I am re doing mine, this time going fluch with the floor (before it was 2 inches below the floor to keep the AUX gas tank)
Looking for ideas

Mark, my rockers were removed, then I cut the inside seam up. Took some 2x6x3/16 box and ran it lengthwise. Used 2x3x3/16 (3) and welded to the frame. Kept the 2x6 outboard a bit (inside edge at inside 'seam') so I push off rocks and can use them with a hi-lift w/o crushing the body :D I'll get pics after work if needed.

http://mysite.verizon.net/res1ukho/sitebuildercontent/sitebuilderpictures/100_0009.jpg
Here is a pic of mine, it's 2x5 rec tube welded to the tub, it's out about 1" from the door and there is about 1/2 below the doorjamb.

Great timing Mark! I'm looking to re-do mine as well. Keep the ideas and pics coming guys:beer:

I am getting ready to do mine, can we get more close ups of those, PLEASE!

Well I already replied in your thread over on classicbroncos.com but I'll copy it here for anyone interested in this thread that doesn't make it over there.

Here's mine:

http://www.dustyland.net/broncos/scb-0411-calico/100_9070.jpg

Here's how I made them (with photos):
http://www.dustyland.net/broncos/tech/rockers.html

Dusty

Link for ya's, can get better when the sun comes out in AM if needed

http://www.rocknroll4x4.com/forums/index.php?act=ST&f=9&t=1568

Great article Dusty, I tied mine to the frame directly, same principle though ;)

I built these a few years ago and have been very happy with them.
http://img202.imageshack.us/img202/5871/rockski6bp.jpg
materials were 2x4 x 3/16 and 2x2 x 3/16 with some 2 1/2 reciever tube at the frame so they are removable. I built heavy because my cage is tied into them.

another pic to show frame mount
http://img379.imageshack.us/img379/6002/dsc008948bl.jpg

edit to add another pic.