Alrighty, Im setting up my front suspension this week and I have my shit together except for this...

I wanna go ahead and weld on my ford shock mounts but I will need to change my pinion as little as 4 degrees, as much as 8 later on. Is this gonna make a difference in my shock mount location.

Cant change pinion angle tommorrow but I can do the mounts and tommorrow is my last day to work on it for a week or more...

I figure it will matter but I would love to get them at least tacked on there tommorrow and ready to burn on later....

Oh yeah, I forgot to say that I also have to cu inner fender to fit them big time with my axle forward and I dont wanna cut and then have to recut (fugly) later on.

It will put a tab bit o fstress on the polly bushins(if that is what you are using), but when that time comes, just hack off the mount on the housing side for the shock?? I havn't ran a toy mount for a # of years, and easy to do(beck when i had toy junk)