in need of exploded 9" diagram

[redranger4.0]

well im starting to reassemble my rear 9" and its not going to gether as planned. i want to get an exploded diagram so that i can make sure im not missing anything of forgetting to put something in.

Andrew

[chrono4]

what is it really that your having problems wiht? its not really all that intensive, really one of the more simple ones.

[NetBSD]

http://www.ford-trucks.com/article/idx/0/065/article/Ford_9_Inch_RebuildGear_Setup.html


did mine for the first time ever following this page, 3,000 miles later my rear is still going

[redranger4.0]

well my problem is when i go to install my shafts it seems like the bearings arent seating far enough in the end of the housing. so when i go to put the plate on it isnt even close to the backing plate of the brakes. this is all going in a 76 EB rear but nothing is stock. im using both a currie housing and yukon shafts which were bought from broncograveyard.com

[redranger4.0]

bump

[NetBSD]

are you useing the sealed bearing on the axel shafts? if you are it will take a bit of fource to get them in there right, i useally use a hammer to get it in far anough then bolt it up and let the bolts push it in, after that hit it a few times to make sure it set in all the way and that the shaft spins.

if your useing the 2 peace bearings make sure the seals going in right, ive seen people bend the seals and caused this. if that happens you gotta pull the bearing off AGAIN and its a real pain

[71BRONCO71]

http://broncograveyard.com/images/catalog/FO9DIA.JPG

theres the pic