|
: Need a few dimension from the xploder guys NothernAZxj 01-16-2006, 07:21 AM can somene one get me dimensions on inside to indide of frame rails and outside to outside athe the tranny crosmember location. also from center of tranny crossmember forward to the cover on the diffhousing.....gots some ideas for a bolt on SAS setup...that wont loose any ground clearance.:smokin: Hyde 01-16-2006, 01:22 PM i should be getting my sploder by the end of the week if you dont have something by then. im thinking bout doing sas as you know with rubicon express tj longarms and grand cherokee coils. whats your idea? NothernAZxj 01-16-2006, 05:02 PM i should be getting my sploder by the end of the week if you dont have something by then. im thinking bout doing sas as you know with rubicon express tj longarms and grand cherokee coils. whats your idea? Im actually gonna design a new crossmember/arm support. to keep the mounts higher less profile Hyde 01-16-2006, 06:27 PM for the long arms? let me know if it works. too bad im a few hundred miles farther north, id let you "test" it on mine lol NothernAZxj 01-16-2006, 06:39 PM for the long arms? let me know if it works. too bad im a few hundred miles farther north, id let you "test" it on mine lol yep long arms. idea would be for a quick swap for tj/xj/mj axle My mom was born in Lewiston:flipoff2: Hyde 01-16-2006, 06:45 PM kool, let me know when you get something figured out. god i hate lewiston lol Bill Plein 01-17-2006, 03:36 PM First Gen only, I assume? NothernAZxj 01-17-2006, 03:40 PM First Gen only, I assume? actually whould like the dimensions for both:D Bill Plein 01-17-2006, 04:26 PM I can get you the dimensions for a second gen. I just grabbed the side-to-side frame rail dimensions. These are rough, there are clearance issues with other stuff and I couldn't get a straight line to measure. 27.5" inside 33" outside. I couldn't get the distance from the cross member forward, i need another person to help. The cross member is at the very back of the tranny, actually where the tranny and transfer case meet. Hyde 01-17-2006, 08:05 PM :bounce2: and so it begins 4x4x 01-17-2006, 10:22 PM I could grab some #'s tommorrow for ya off my 93...its cold and rainy right now oh and do you mean the center of the tranny xmember to the front of the beam? There isn't a diff cover... NothernAZxj 01-18-2006, 06:36 AM I could grab some #'s tommorrow for ya off my 93...its cold and rainy right now oh and do you mean the center of the tranny xmember to the front of the beam? There isn't a diff cover... LOL yep....wher the cover edge would be....its kinda molded in 4x4x 01-18-2006, 11:15 AM Ok... Inside to inside:26.25" Outside to outside:31" Center of x-member to front edge of beam:~42" hope those rough measurements helped:smokin: | |