cleanin out the garage. i have a 3rd member from the rear of my toy, with an arb in it. heres the story so read it thoroughly! the prior set of ring/pinions were good, but the pinion nut backed-off, putting teeth marks in the arb itself. i replaced the ring/pinion's and proceeded with nothing wrong. ARB worked fine when i was running the new r/p's. 6 months or so later, i snapped the ring/pinion again! after making some phonecalls at the time(i think it was near 8 months ago), r/p's were a 3 month minimum backorder from 3 dealers i contacted. a friend of mine in sly park had an open 3rd member with the 4.88's i needed so i got it. the ARB/3rd member has been sittin in the garage since then. well, i need to make room so its for sale. it worked completly fine when i pulled it out and there are pinion marks on the outside of the housing. im asking 450 for the arb and an extra 100 for the compressor. im located in sacto, near arden park, and NO, im not shipping it. if your serious, give me a call if you want it or wanna check it out. i need it outta my garage!!!

phil
916.212.1279
leave a message and ill call ya back, i dont answer the restricted/non local.

Keep it and put it in your front 3rd! DON'T SELL IT!!! U WILL REGRET IT!!!

:eek: ttt:eek:

:cool2: SOLD SOLD SOLD SOLD SOLD SOLD SOLD :cool2:

did you sell the compressor too?