Who out there is making the Tall 1350 yoke for the Dana 60?
I did search with no luck.

http://www.partsmikeparts.com/yoke_1350.htm

~Mike

http://www.partsmikeparts.com/yoke_1350.htm

~Mike

x2, I have bought both of my 1350 tall yokes from Mike.

Newbie question - How do you determine whether you need a "tall yoke" or stock/short one? Is it just a matter of mock-up and see if your ok?

Newbie question - How do you determine whether you need a "tall yoke" or stock/short one? Is it just a matter of mock-up and see if your ok?

Try and determine what the operating angle of your driveshafts will be and that will let you know if you'll need one. If there is any doubt, you may as well get the tall yokes if you need new ones.

I really don't see you needing one on that HP 60 you have (unless you have an insane amount of lift), those DS angles are gravy... I have never seen a tall yoke for the 14 bolt.

Thanks sw99 :)

Got a 1350 right now but not even close to mocking up DS, or diffs under vehicle

Thanks I will give him a call.
R/T