I am hoping that someone knows where I can find something like this that will seal against a standard 4bbl carb and/or include a sealed filter housing?

http://imexindustries.com/fiat/fiat500flrairfiltercover.jpg

I did some more searching on ebay and found these. But none of them have any provisions for a filter housing?

http://i9.ebayimg.com/03/i/04/0b/43/0c_1.JPG

I am hoping to find something with a 4" inlet??

http://images.racepartsdirect.com/EVPA-00.jpg

http://www.optionracing.com/images/eBayPhotoNE/AirIntake/D1X03C.jpg

http://i12.ebayimg.com/02/i/04/38/af/22_2.JPG

http://i5.ebayimg.com/02/i/04/2b/1f/b4_1_b.JPG

http://images.racepartsdirect.com/EVPA-00.jpg

that is the one that all the real fast turbo/carb guys are using.
it has been in the 7s on a small block Ford

not sure I understand the filter housing part of your query.
run a tube to whatever filter housing you want.

I am using the side of an industrial intercooler as my intake scoop for the top of the buggy and it is 24" long by 3.5" high and had a 4" outlet facing down towards the engine. I don't want to have an open element filter mounted there because the first overgrown trail and it is gone or crushed.

I may end up ordering this one and then use my bender to make a double intake but I would like something with a bit of a scoop.

http://i14.ebayimg.com/04/i/05/fc/60/2c_0.JPG

It has dual 2" inlets. I don't want to starve the 406.


I want to be able to drown the motor without worries too much. I have lots for the other systems just not the intake?



I also have 2 of these to help but they take up a lot of very valuable area I don't have. They are from a Jag XJ6.

http://i19.ebayimg.com/04/i/04/b4/9d/af_1_b.JPG