pass drop d44 in yj

[88 mangler]

im in the middle of putting a pass drop waggy d44 in my yj and cant get it centered in there. its off by about a inch. can someone post some pics of theirs so i can see what im doing wrong.

thanks clint

[NE-RokToy]

measure twice cut once......

if the spring perches are centered and match up to your spring mount width it will go in just fine. Something aint right if the axle isnt centered when bolted in.

[88 mangler]

the thing is the spring wont go over far enough because the u-bolt hits the housing.

[88 mangler]

i had thought about putting studs in instead of u-bolts, like on a d60. anyone try this before?

[88 mangler]

i know someone on here has done a pass drop waggy d44 in a yj. PICS PLEASE!

[Paramount]

my scout axle(pass drop) on my yj is perced in the housing to let the ubolt through, its late now, but ill try to take a picture tomorow for you just leave me an email to foward the pic

[bp95yj]

I'm not sure if the measurements of a pass. drop and driver drop are the same but on my pass. drop waggie axle, the spring perch in stick welded onto the housing. The inner u-bolt slips into a notch that I ground out on the housing so that it fits

I don't have any pictures but if the offset of the housing is the same for a pass drop and a driver drop, Keith Strong used to have some good pictures of his YJ with a driver drop waggie axle, that may help you

Brandon

[bp95yj]

http://www.pirate4x4.com/forum/attachment.php?attachmentid=141485&d=1091805711

this is from sandiegocj in a older thread

[bp95yj]

sorry computer problems, I deleted the extra posts

[bp95yj]

sorry computer problems, I deleted the extra posts