I lost my booklet that listed what the clearances should be...anyone have them? I think they were around .009" to .019":confused:

These clearances are critical...if your lockrite is too loose it will not be able to lockup and the teeth will just scrape by each other until they start breaking off :(

PS This is the lockrite that I've had in the back of my cruiser since '94:eek: and now it is going to be in the front (welded the dana 60 rear;) )

Clearance to center pin = .005" to .020". Clearance on both sides must be with in .002" of eachother. If my feeble memory serves that is.

HTH.

Later.:usa:

Thanks!:beer: