|
binderbasher 02-09-2006, 09:16 AM Does anyone have pics of the front passenger spring plate, and ubolts? I am using 5/8 ubolts. I am trying to figure out the best way to mount my springs (soa) on that corner. I would look through old threads but I am using a friends computer because I dont have one yet. Thanks ihojeff 02-09-2006, 09:22 AM Fab a new spring plate. Use at least 1/2" plate, drill 5 holes, and you're done. ________ The View (http://pattayaluxurycondos.com) binderbasher 02-09-2006, 11:13 AM The attached web sites are cool, I did not know their was anyone other then anything scouts in california. Brandon 02-09-2006, 11:29 AM I'll bite, what is different about that spring plate than any other plate? ihojeff 02-09-2006, 11:37 AM When you go around the front housing it requires bigger u-bolts that almost always don't fit thru the stock u-bolt plates. Binderbasher, I do have in stock aftermarket u-bolt plates. PM or email if interested. ________ Water bong (http://glassgallery.tumblr.com/glass-bongs/) Brandon 02-09-2006, 11:46 AM look like this? http://rcrc4x4.com/shop/images/3holeplate.JPG what attached sites? Anyway, buy em from ihojeff :beer: ihochad 02-09-2006, 12:31 PM look like this? http://rcrc4x4.com/shop/images/3holeplate.JPG what attached sites? Anyway, buy em from ihojeff :beer: He is talking about Jeff's and His Brother's sites. The Pumpkin is the difference on the passenger side. And I sencond that, just buy them from Jeff. RustoleumWhite 02-09-2006, 03:57 PM I use stock Chevy spring plates... but then I use a Chevy housing and just buy the Rancho u-bolt kit from my local 4x4 shop for the correct year Chevy axle. For me, that is the simplest and you can usually get the plate free or super cheap. Jeff's look pretty nice though.... but I'm a cheap bastard :flipoff2: Brandon 02-09-2006, 06:12 PM I dunno if that is what Jeff sells, that is what I have - from Foothill ;) ihojeff 02-09-2006, 06:25 PM The new one's that I just started stocking from a different manufacturer look almost the same as your's Brandon. I have some that are thinner but will be phasing those out since I prefer the 3/8" thick ones. ________ VenusGoddess (http://www.girlcamfriend.com/cam/VenusGoddess/) binderbasher 02-11-2006, 10:35 AM IHOJEFF check your pm, Thanks binderbasher 02-11-2006, 10:43 AM The Reason I Was Searching For Custom Plates Is (1) I Intend On Using Bigger Then Stock Ubolts (diameter), And (2) I Grinded The Perch Surface On The Pumpkin Side Even With The Raised Edge Approx 1/2 Inch Larger Tube Circumfrance. Thus The Tube Is Approx Four Inches Around, Insted Of Three. Stock Ubolt Spacing Wont Match. The Stock Plates Are Too Weak For My Taste Anyway. So Is The Steering, And Other Things, But I Have To Go With What I Can Afford. | |