so i just rebuilt my warn xd9000, i thought i had marked the wires right so i could hook it back up but i think the marks got rubbed off or the tape fell off or something, point being its not working and the warn web site doesn't do a very good job at explaining how the wires go, to make things worse its inside an arb, er, so space is real tight, it was getting juice before i took it off so im kinda ruling out corrosion on the connections, i doubt anyones prepared to take their cover off and look at it just to help me out, but give me a shout if you know of any good diagrams/ pics/ sites that could explain it. or if you were god you could just explain it to me off the top of your head. by the way i did spend a hour on here yesterday searching so.. ya don't yell at me about that.

ok this is what im going off of, on pg 6 of the warn xd9000 operators manual off their web site there are three black wires that go from the solenoid to the top of the winch, A F1 and F2, and theres a little black wire.

Here's a pic from http://www.4x4wire.com/tech/winch/remote/ that might help it's an XD9000

http://www.4x4wire.com/tech/winch/remote/wiring.jpg

Try calling Warn? 800-543-9276

the one in the picture is a xd9000i i have just the xd9000 (no i) the one with the remote solenoid so it looks different, i just remembered theres this guy who has the same setup that lives near me that im going to hit up when he gets back into town, hopefully once i see his i will be able to figure it out, thanks though