|
redrocket_78 02-12-2006, 10:03 AM Anyone done this? I am looking to fab one up for my brother. Exhaust clearance issues. Looking to make the cross member and then a flat skid below. Easily removable to work on the drive train separate from the cross member. Chad. XJ_ranger 02-12-2006, 11:46 AM get that sledge hammer ready for the floor... currupt4130 02-12-2006, 01:31 PM This is a terrinble idea, I don't know what your thinking, XJ's have a unibody and can't take that stress, jeeze what are you thinking? Hey Chad :flipoff2: My input is to plate the frame with 1/8 or 3/16 where you weld up the tabs for the x-member. wrangler bushings on each end and push it as high as you can. redrocket_78 02-12-2006, 02:02 PM Hah. I should have known you were going to trash me here. Post #2. But thats what I was leaning towards. I'll probably just crawl under there and start building. Chad. currupt4130 02-12-2006, 02:35 PM Chad it was too easy, i saw your name and went "oh this will be fun". Anyway, I'd try and use 1x1x3/16 tubing, and weld on a lip for the the tranny to sit on and bolt to. Angle iron for the lip allows your to weld it a lot more than just a piece of plate on the bottom |[]__ zjmikey 02-12-2006, 02:52 PM go here.. www.tntcustoms.com they make a nice one already....... currupt4130 02-12-2006, 09:09 PM btt currupt4130 02-13-2006, 02:34 PM btt for a friend | |