|
steve&2jc's 02-17-2006, 06:05 PM I'm getting an hp30 from an xj to put in my tj. It has the axle disconnect on it. What do I have to do to eliminate this so it'll work in the tj. I'll be using my arb and chromo shafts and know that I'll have to get new gears for the hp. Thanks mrboyle 02-17-2006, 08:23 PM Other than swapping in your axle shafts you will need to make a plate to cover the hole where the disco bolted on. muddy_xj 02-17-2006, 08:24 PM There is a seal kit that I believe is available through Randy’s ring & pinion that will appropriately seal off the shifter housing. steve&2jc's 02-18-2006, 01:05 PM Thanks for the info. Murfman 02-19-2006, 10:26 PM why not just use the disco cover it comes with and plug the holes? Radbassist 02-19-2006, 10:43 PM WARN has a kit too for manual hubs that comes with a disconnect cover too planefixer 02-20-2006, 07:56 AM Inner axle seals will need to be replaced as well. | |