heres a couple of pics. it did 30+ ins on the forklift with the frame level. later mike
http://bbs.off-road.com/wwwthreads_uploads/53-543269-trackerflex1.jpg
http://bbs.off-road.com/wwwthreads_uploads/53-543271-trackerflex2.jpg
http://bbs.off-road.com/wwwthreads_uploads/53-543273-trackerflex3.jpg

is that a sidekick axle with 35s? what are you doing for springs? coils?

[ 09-17-2001: Message edited by: poppycock ]

What type of ends are using on your links? Can't tell, is the link on your diff connected? <IMG SRC="smilies/smile.gif" border="0">

[ 09-17-2001: Message edited by: fatkid ]

Originally posted by poppycock:
<STRONG>what are you doing for springs? coils?

[ 09-17-2001: Message edited by: poppycock ]</STRONG>

With a three link he going to run leafs. <IMG SRC="smilies/thefinger.gif" border="0">

he could be doing that shackle front and rear setup... that would require a 3 link... or maybe 1/4 ellipitic... 3 links aren't just for coils. <IMG SRC="smilies/rolleyes.gif" border="0"> a 3 link with solid mounted leaves might be a whole lot work for something a simple trac bar could handle. but maybe he wants to waste time. <IMG SRC="smilies/laughing.gif" border="0">

[ 09-17-2001: Message edited by: poppycock ]

it is a stock tracker rear three link set up. that we cut and extended three ft. it uses the tracker ball joint on top of the pumpkin. and the lower arms are just stock ones cut in half and slid into 1 5/8 tubing and welded up. the upper link is made out of the old parts from the tracker. it is going to have 1/4 eliptic spring set up. more than likely out of a chevy pu springs. not sure yet, will keep you updated. later mike