Does any one know where I can get the steering arm that goes on top the knuckle for a Dana 44 out of a 74' Bronco so that I can go to steering over.

you will have to swap knuckles.

Try www.bcbroncos.com

They sell a knuckles-over kit that uses a tapered bushing. You'll have to use a tapered reamer on your present knuckles.

It's essentially an F-150 set-up that the tie-rod has been cut down in length and re-threaded on a lathe ( singlepointed).

What are you looking for? I think you have some of the slang wrong
Tie rod over, is what BC bronco's sells, that just puts your tie rod on top of the kunckle insted of bloew it

High steer is where you would need arm, it uses a flat top kuckle and puts your steering way up high,, this i almost impossibale with a EB because of the trac bar

I am acutally looking for the part that my drag link will bolt up to

Originally posted by welndmn
this i almost impossibale with a EB because of the trac bar

It is :confused:

Originally posted by kbebout
I am acutally looking for the part that my drag link will bolt up to

Your drag link bolts to a tie rod and your steering box?


Yeah its very hard, i did see one guy with High steer, he put his trac bar behind the axle, very neat, but IMO, probally not worth all of the time he spent on it

Where exactly is the clearance problem? The high steer arms really aren't that much higher than just doing a tie rod flip. I picked up some flat top knuckles, so I was going to do the high-steer for the hell of it. Guess I better go look things over before I commit.