I finally put a 420 in to get me through the year with my current cruzah. The whole deal went smooth other than a small throw-out bearing problem. When i went to mount up the driveshafts came the problem. I used the plate made by extreme bends and it moved my case foward about an inch(at least it's in the right direction). My rear shaft is borderline but it should work, my front is another story. The slip is shot, the short side has a couple of cracks in it. I just got material to retube it( my local shop would only go 120 wall:rainbow: )but i really need a female from a early cruzer here in the east bay. Can anybody help?:confused:

I think I have what you are looking for. You need the small bolt pattern slip yoke for a 3 speed t-case?

If this is what you need, send me an email or PM.

I emailed you, sounds good to me.