I have a Dana 300 T-Case. I have heard that it is possible to convert the output on the case from the Flat Strap bolt to the stronger U-Bolt.

I would like to be able to run a CV on the front and rear.

Does any one have information for this conversion or part numbers?

If you want to run a CV you will need a new yoke, spicer pn 2-4-4341. This is for a 1310 series CV.

Thanks for the info.

:beer:

yoke from a GM 44 front end. :beer:

Originally posted by FULLSIZE
yoke from a GM 44 front end. :beer:

or a scout front or rear, or a waggy front or rear, or a........


by the way i have a 1310 cv yoke for a d300 if you are interested pm me.

i thought they might, didn't know for sure.:D

There was a thread a while back, and I posted the dana part number and everthing. So try a search.

It is the D44 yoke, like mentioned before.

The d44 yoke is a pn 2-4-8091x and uses ubolt kit pn 2-94-28x. This yoke will not work if you want to run a CV.

would a yoke from a 97 ZJ NP242 work?

So we have 3 people saying that a dana 44 yoke will work with a 1310 cv joint and 1 guy saying NO. Which is it? I need to run a cv shaft and I think a new yoke will be like $50, but what the hay if I can get it from a junk yard for a drop in the bucket! I looked at my 44 front and I don't see why it wouldn't work with the cv cause the holes arent' threaded and a bolt would go thru?

Originally posted by desertCJ
So we have 3 people saying that a dana 44 yoke will work with a 1310 cv joint and 1 guy saying NO. Which is it? I need to run a cv shaft and I think a new yoke will be like $50, but what the hay if I can get it from a junk yard for a drop in the bucket! I looked at my 44 front and I don't see why it wouldn't work with the cv cause the holes arent' threaded and a bolt would go thru?

well the post title is about converting from straps to u-bolts. for this yes the d44 yoke will work. if you want to run a cv then you need a different yoke.

Thanks for clearing that up for me. I'm still curious what the difference is? I dont make me pull my front shaft and bolt a cv joint to the axle:D Looks like I might have to try it to satisfy my curiosity.

I heard a bad rumor today that Spicer was discontinuing the manufacture of Ubolt style yokes in favor of only making strap style.

Anyone hear that and can confirm or debunk the ugly rumor?

Ed

You can also call jess at highangle drive line and see what he can make for you..

The d44 yoke is a pn 2-4-8091x and uses ubolt kit pn 2-94-28x. This yoke will not work if you want to run a CV.


Will this same part# work on a NP231 font output? The front TJ yoke from 4wd harware is $140 and that seems a bit pricey to me. Any alternative suppliers? I was thinking of calling advanced adapter about this.

Originally posted by SCORPION



Will this same part# work on a NP231 font output? The front TJ yoke from 4wd harware is $140 and that seems a bit pricey to me. Any alternative suppliers? I was thinking of calling advanced adapter about this.

What. you have to buy NEW? 4wd harware is a rip off no mater what you buy. a YOKE could be picked up pretty cheap even at an expensive junk yard. its not like they go bad. unless their just broke...