I just picked up a front 60 too swap into my toyota.It's a dually front, is there any differance between the dually front and the single wheel front 60's other than the width? I been reading up alot and I know that I can swap it too make it narrower. is there any difference in strength? any info is greatly appreciated,thanx guys.

No difference in strength. You can either swap out the hubs to go narrower or modify the bearing hubs. To modify the hubs you will need to remove the bolts that hold the rotor to the bearing hub and place lug studs through those holes. Then you have to machine the outer ring OFF where the studs where located when you bought it. Once you have done this you have converted it to a single wheel front. Good luck..If you need any additional info PM me or search if the search function is working..There are plenty of threads about this on the board..

Then you have to machine the outer ring OFF where the studs where located when you bought it.
The thing I like about this is that if you run lockouts they are totally protected from rocks by the hub cup.

sweet. just the information I was looking for. thanx guys I appreciate it. :smokin: