best way to install new races in hubs [Archive]

BlueBeast

04-03-2002, 07:02 PM

was going to use the old bearings to tap them in. anyone have a better way?

ranger

04-03-2002, 07:59 PM

If you don't have a bushing driver, perfered method, use a brass drift. Put the race in postion so its square with the hub, and gently tap it in place, hitting the outer edge of the race. Do this working in a alternating pattern, around the circumference of the race, so it goes it straight, not in an angle.:skull:


Pirate4x4.Com > Brand Specific Tech > Chevy > best way to install new races in hubs PDA : best way to install new races in hubs BlueBeast 04-03-2002, 07:02 PM was going to use the old bearings to tap them in. anyone have a better way? ranger 04-03-2002, 07:59 PM If you don't have a bushing driver, perfered method, use a brass drift. Put the race in postion so its square with the hub, and gently tap it in place, hitting the outer edge of the race. Do this working in a alternating pattern, around the circumference of the race, so it goes it straight, not in an angle.:skull: