|
Badburn 03-02-2006, 11:11 AM Does anyone know if the gears from a rear dana 60 will work in a front dana 60? Im not sure if they are cut backwards or what? Also, are there different dana 60's or are they all the same as far as gears go? thanks GiS 03-02-2006, 11:36 AM Front Dana 60, is it a High pinion? If so, HP diffs are reverse cut/reverse rotation. Badburn 03-02-2006, 11:53 AM the front is a low pinion Davethorik 03-05-2006, 12:02 AM then yes it will use the same gears and carriers as the rear, just watch your spline counts. Ramboss429 03-05-2006, 01:40 AM If its a LP 60 just as well throw it away an get a HP. Badburn 03-05-2006, 12:49 PM That sounds like a good Idea, in what vehicle would I find a high pinion passenger drop 60 front? Davethorik 03-05-2006, 01:04 PM If its a LP 60 just as well throw it away an get a HP. What??:shaking: EDIT: oops...misread what you typed. my mistake. That sounds like a good Idea, in what vehicle would I find a high pinion passenger drop 60 front? There isn't one, unless you re-tube a Ford axle. s1037s 03-05-2006, 06:51 PM if it's coarse spline, i would upgrade the gears now because yokes are not as strong in the coarse stuff... | |