|
: newbie with a dana 44 question gmule 04-04-2002, 07:58 AM I posted this question over at colorado k-5 and Pirate4x4 was higly recomeded as the best place to post this question so here it is. Will the rotors and spindals off of a 80's chevy 3/4 ton with a dana 44 fit on a 80's 3/4 ton Dodge knuckle that is also on a dana 44? thanks for any help, Greg hy_desert_4wheeler 04-04-2002, 04:01 PM Yes they will fit.. But why??? Old Syko 04-04-2002, 04:12 PM I must be dense today. What will you gain?:confused: FULLSIZE 04-04-2002, 04:19 PM he probably drives a dodge and got the GM stuff for free. dont you know they give away anything that came from a chevy!:laughing: Old Syko 04-04-2002, 04:26 PM Just goes to show. GET WHAT YOU PAY FOR:rolleyes: gmule 04-05-2002, 04:39 AM I swapped axels from a 78 full time 3/4 ton to my 88 Ramcharger. I got the bennifit of a dana 60 for the rear,4:10 gears and I no longer have that cheesy cad setup from the 88 axel. I had the knuckles from the originall axel hopeing to put on dodge spindles and rotors to convert the full time axel to a partime unit. I was unable to locate dodge parts for the conversion. Chevy parts are a dime a dozen and if they fit I'll use them until I can afford a dynatrack 60 for the front. I appreciate the input from you guys and hope to wheel as hard as you guys do. Thanks Greg hy_desert_4wheeler 04-05-2002, 04:08 PM The knuckles on the fulltime unit are completely different and will not accept part time spindles.. You will need to change from the knuckles out.. | |