is there an ez way to get the hub body separated from the roter? its from an 85 toyota solid axle..and has been sitting for a long while

you get a hammer and hit the studs out becarful not to mess up the threads. or take it to a maching shope to and have them pull the studs out with a press. i just used a hammer to take them out. but when you put the studs back in its a good i idea to have a maching shop press them in, to make sure there all the way in.

NEVER hit the fawking studs :shaking: always thread the lug nuts on half way through the lug nut and use that or youll mushroom the stud and itll be trash, that being said when you take them out its better to replace them if they are old, they are like $0.89 each for a 1/2 ton pickup at my local shop, $1.98 for 3/4 and $2.12 for 1ton