Dana60 Billet Steering Arms...Now Plated!!

[TJ Fan]

Our steering arms are fully machined from one chunk of steel (2 inches thick) and feature the following:

:grinpimp: Built in Caps and Locks
:grinpimp: Angular Correction
:grinpimp: 5th Hole for Dedenbear Knuckles*
:grinpimp: Tap for Grease Zerk
:grinpimp: They are now all Bright Zinc Plated For Corrosion Resistance!

These now look like they have been chromed!


These are big pimpin compared to the laser cut arms you see some retailers selling.

*Note: ARP studs available from Dedenbear are 0.500. Steering arms have been reamed for clearance for these ARP studs. For use with factory studs, arms will need reamed an additional 21 thou.

Cost:
Single Arm- $120
Pair of Single Arms- $220
Double Arm - $180
Double Arm and Single Arm - $280



In stock and ready to ship. Contact us at 330.549.9082 to place your order.

Thanks,
Larry

[TJ Fan]

#1

[TJ Fan]

#2

[Dazz]

How much are the ARP studs needed?

[TJ Fan]

The studs with nuts are 35.00 per arm. They are chromo. You also can get the knuckles reamed to the correct size, but the ARP studs are the nicest way to go in my opinion. If you have any questions, give me a call @
330-549-9082

Thanks,
Larry

[rockhumper]

I'll call you in the morning need 2 set's of single arms.

[TJ Fan]

:d