Where to buy 7/8" - 18 Taps

[TXtac]

I have looked for the search function, but I don't see it. :shaking: But, I need to get some info.

Where is a good place to buy a 7/8" - 18 Left Hand Tap for TRE's? I have found the RH taps all over the place, but have not found the LH taps for under $100.

Any help would be appreciated.

[big specht]

LH taps arn't going to be cheap I think I payed around 85 to 100(been 3 or4 years ago) I will look to see where I bought mine at I want to say GOODSON'S ? or that might have been the ream?? When you find one get the 6 flute ones they seem to cut faster and hold up better I have both 4 and 6 flute and the 6 has held up longer than the 4.

[trkklr77]

i got mine from AIR-GAS and they can be found in mcmastercarr.



http://www.mcmaster.com/

[CanuckJeeper]

Just under 100$:

http://search.ebay.com/search/search.dll?cgiurl=http%3A%2F%2Fcgi.ebay.com%2Fws%2 F&fkr=1&from=R8&satitle=tap+7%2F8+left&category0=

[Aces'n'8s]

You may also wish to look at these companies.

MSC (http://www1.mscdirect.com/CGI/N2DRVSH)

ENCO (http://www.use-enco.com/CGI/INSRAR?PMSECT=0002010822)

[steveh]

http://www.e-taps.com/index.htm

Bought both from these guys, great deal, fast shipping

[TheBandit]

http://www.e-taps.com/index.htm

Bought both from these guys, great deal, fast shipping

Thanks for the link Steve! Great pricing. :cool2:

[TXtac]

Thanks for all the links ya'll. I will be checking them all out.

[steveh]

Thanks for the link Steve! Great pricing. :cool2:

The Taps are top notch, mine have been used several times in a lathe to make tie rods and drag links, and work beautifully.