Hi there,
Does anyone knows where the crankshaft sensor is located?

I changed the water pump,thermostat,belt(serp.) and finished the job and went to start the '95 classic rover and it would not start. It sounds like it wants to turn over......any ideas:confused:
Thanks

Didn't know that a '95 classic had a crankshaft position sensor. Should have a distributor.

Do you have a spark? Check the coil wiring. Somtimes one of the little wires get pulled off when messing around changing belts etc.(should be 4 of them, 2 white and 2 white w/black tracer, can only go in one place due to the terminal type).

Matt Browne
Overland Engineering

The '95 Classic does not have a CkP. The '95 4.0/4.6 does.

The work that was done is not undertaken in ana ra that would lend itself to easily causing a no-start condition.

"it sounds like it wnats to turn over"??? is it cranking?

Could be your amplifier module. But then again it could be a lot of things.

I will check the wires. it's cranking, fuel is it at the rails.......
Thanks for the info.