I tried to search but didn't get any good results. What vehicle has a 35 spline FF rear axle in it?

Craig

Also how do I identify one???

ill sell you one 64" WMS out of a dually dodge truck, 4.10s, $300 in MA.

Originally posted by 9-Volt
ill sell you one 64" WMS out of a dually dodge truck, 4.10s, $300 in MA.

I'm looking to cut one up for my HP 60 rear, so I'm looking to use the axles spindles and hubs. And I want to do it cheap.

There's a u-pull-it around here that sells axles for 100-150 and if I know what to look for I will get one from there.

Craig

Originally posted by CrazyCraig
I tried to search but didn't get any good results. What vehicle has a 35 spline FF rear axle in it?

Craig

Dana 70 rears have been used by chevrolet,ford,dodge, and international and the old kaiser jeep trucks. Usually found in one ton pick-ups and one ton vans..When looking for one make sure to pull an axleshaft.Most 70 rears came with 1.5 inch 35 spline shafts .However, some newer ones have a smaller 32 spline shaft and some older ones have 1.5 inch 23 spline shaft.By the way it will have 70 stamped in the housing next to the inspection cover and it will look like a 60 but bigger..Hope this helps you out.:D

My hd dana 60 is a 35 spline ff with 4.88's came out of a 1973 winabago brave moter home