Does anyone have any experience with running an output yoke that will fit a 1350 CV or non-CV rive shaft. Advanced adapters tells me that it cant be done, but I dont see whay you couldnt take an NP 205 output yoke and have the shank machined to fit the seal. Also there is an article in this months JP where theyt put the yoke on with this kit, but they dont mention any issues...


Anyone try it with a 1410?:p

Thanks,

Ryan

I ordered my 32 spline kit with a 1350 non CV yoke from Parts Mike. No additional cost.

Jesse at High Angle can hook you up with a 1410

I think Jess can hook you up,I got a 32 spline 1350 cv type from him:D
although it was for a Atlas rear,i think it's the same

Rob

Thanks for the help guys,

Ryan

here's a pic- Jess