35 spline 9" ???

[redranger4.0]

If everyone says you cant fit 35 spline shafts with out a 3.25 case what do they make this for?

http://completeoffroad.com/wsm/i-932_add_full_steel_spool_35_spline_small_carrier_b rg.html

i was under the impression you could only fit the 35 spline with the bigger bearings? am i wrong?

[Captain Air Time]

If everyone says you cant fit 35 spline shafts with out a 3.25 case what do they make this for?

http://completeoffroad.com/wsm/i-932_add_full_steel_spool_35_spline_small_carrier_b rg.html

i was under the impression you could only fit the 35 spline with the bigger bearings? am i wrong?

Typically, that would be the case. This might be a piece that is machined paper thin to fit a standard bearing. Is there room to lose .095 all around, and still maintain strength? I'm no metalurgist or engineer, but I'd avoid it until I saw someone beat it as hard as I would. or failing that, at least TRY to :D

[welndmn]

Because the carrier bearings are wicked small.