Ok i got an 85 Chevy Military Tug truck .6.2 Diesel 400 Tranny NP208 anyways all steering and brakes are full Hydraulic WHat is the proper precdure for Bleeding these Brakes and WHat type of FLuid do I use any HELP woudl BE GREAT

THANKS
CASEY

there is nothing special about that brake setup. its the same as anyother 1 ton chev. just use dot 3 fluid and bleed them like normal.

pump pump pump Hold Crack bleader, Tighten bleader pump pump pump hold crack bleader Add fluid Next wheel. do that untill No air,

Start at the wheel farthest from your MC, and work towards it. Right rear, left rear, front right, front left.

Start at the wheel farthest from your MC, and work towards it. Right rear, left rear, front right, front left.

x2

Start at the wheel farthest from your MC, and work towards it. Right rear, left rear, front right, front left.

Your right as far as start with the wheel farthist away but it's the l. rear.your hard line going to the left is longer than the right.

Your right as far as start with the wheel farthist away but it's the l. rear.your hard line going to the left is longer than the right.


not always true, the drop point is different on so many vehicles its not even funny.