Are these the same as a d60 front? I just bought a complete d50 front hub to hub for $50.00 so I couoldnt go wrong since my tow rig has the same front axle.

yes. The spindles won't work unless it was a balljoint 60 but you can use the ones that come on the dually 60 if you are triing to convert it to single wheel. The spindles wont work because the register is too short so the studs would carry the load.

Hey thaqnks 66cjdean. I thought the dana 50 bearing hub looked just like the d60 ones. The hubs are the same as well. I think they are 30 spline.

What years of dana 50's shared the dana 60 hubs. The earlier ones I know are smaller, does anyone know when they went to dana 60 type hubs? Are the stub axles the same as dana 60 ones? Thanks.